Mightymount Switch

Key Features

With an identical hole pattern as old school deck mounts this mount can be used to switch to a deck mount that accommodates modern track accessories without the need to drill more holes. Compatible with the YakAttack LockNLoad™ mounting system and with other MightyBolt accessories. For kayaks with pre-threaded inserts, additional hardware may be required.

• Made in the USA
• Covered by our Built for Life Guarantee
• SKU: MMSW

Instructions for Inflatable Kayaks: **Please do not use Loctite or a threadlocker that reacts with plastics**

• Locate the red bag of hardware containing nuts, washers, and LONG screws and discard them. They will not be used for inflatable kayak installs.
• Position the MightyMount Switch on your YakAttack SwitchPad or other inflatable mounts.
• Locate the SHORT 1/4-20 x 5/8" long stainless screws in the bag labeled, “Hardware for Inflatable Installs.”
• Insert a SHORT screw into each hole of the MightyMount Switch.
• Hand tighten with a Phillips Screwdriver until snug. Repeat steps 3 and 4 for the rest of the hardware. 
• After all screws are installed, fully tighten, being careful not to over tighten.

Instructions for Rotomolded and ABS Kayaks: **Please do not use Loctite or a threadlocker that reacts with plastics**

• Locate the Hardware for Deck Mount Installs
• Position the MightyMount Switch on the surface where you want to install it.
• Using a hole in the MightyMount Switch as a guide, drill the first hole using a 17/64” drill bit.
• Drop a LONG 1/4‐20 screw through the MightyMount Switch and into the drilled hole. This will prevent the MightyMount Switch from sliding around as other holes are drilled.
• Repeat steps 2 and 3 for the rest of the holes.
• Once all holes are drilled, remove all screws.
• Apply marine sealant as desired into hole and/or on screw threads.
• Install first screw with washer and nut on inside of hull, but do not fully tighten.
• Repeat steps 6 and 7 for remainder of screws.
• 1After all screws are installed, fully tighten, being careful not to over tighten.